Change Engines & Vehicles from Negative to Positive ground earth 

THE BENEFIT IS THE ENGINES AND FUEL LINES AND INLET MANIFOLD WILL EXTRACT ELECTRONS FROM GAS FUELS.

THIS MAKES MORE POWERFUL  RESULTS FROM GREEN FUEL WHICH HAVE BEEN FRACTURED WITH GAS PROCESSOR.

 

Engine becomes part of the electron extraction  circuit

Conversions

,,You have three phases ,,One end of the three goes to ground yes three wires together go to ground and on the other end you have the three wires attached to a three diode pcb and then go to your positive pole on the outside,,,So you could just put the diode pcb on the other end to new positive ground and use the old positive pole for your negative…..You also have your center feed 0 to 12 volts this creates the magnetic field needed to push electrons through the outer three phases we have just talked about,,,I don’t think you need to swap polarities but you prob can if you like but should make no difference,,,,,Or just isolate from car and swap poles.....

I imagine you just pull the rectifier out of the back, so the negative output isn't connected to the alternator frame.. Then, get yourself a couple high amp diodes and make your own FWBR

Stanley Meyer Change Negative to Positive Ground Earth to extract electrons
Stanley Meyer Change Negative to Positive Ground Earth to extract electrons
Stanley Meyer Change Negative to Positive Ground Earth to extract electrons
Stanley Meyer Change Negative to Positive Ground Earth to extract electrons
Stanley Meyer Change Negative to Positive Ground Earth to extract electrons

One of the key points

 is that Stanley A Meyer Rewired the alternator in several ways to not only raisee the voltage

by using thinner wire but also lower amps but using resisive wires.

 

It is vital to note he switched the alternator to positive earthed/ positiv ground 

TRaining Slide Alternator jp.jpg